EPS foam is a thermoplastic material. After heating and foaming, it contains 3-6 million independent closed bubbles per cubic meter of volume, and the volume of air contained is above 98%. This structure gives it many characteristics. Since the density can be as low as 10-30kg / m3, EPS is currently the lightest packaging material. Under high load conditions, this material will be bent. When shocked or dropped on the ground, it will cushion. And shock resistance; At the same time, because the air's thermal conductivity is very small and it is closed in the foam to prevent convection, EPS is a material with excellent thermal insulation properties

Products Photos








Expanded Polystyrene, also known as Expandable Polystyrene (EPS), has a small relative 

density (1.05g / cm3), low thermal conductivity, low water absorption, shock resistance, 

heat insulation, sound insulation, Moisture-proof, vibration-damping, excellent dielectric 

properties and other advantages, widely used in machinery and equipment, instruments, 

household electrical appliances, crafts and other shock-resistant packaging materials that 

are easy to damage valuable products and fast food packaging.



eps raw material catalog.png




Packaging / New Building Materal / Plastic Foam Flotation / Decorating Material 

Full Mould Casting / Protecting Material / Filter Material






Packaging & Shipment




                    PACKING          WEIGHT/KG    20'FCL CAPACITY    40'FCL CAPACITY
       Paper Bag
    (Laminated Kraft Paper)
                  25             17.00MT              17.00MT
                 800             16.00MT              16.00MT
       Flecon Bag
      (Super Sack)
                 850             17.00MT              17.00MT
                 975             9.75MT              9.75MT
                1000             10.00MT              10.00MT
                1200             12.00MT              12.00MT


EPS Raw Material Storage



Prevents Accumulation of Pentane Vapor

1. Because pentane vapor is heavier than air, it can accumulate in depressions, restricted 

areas (trailers, boxes, waterways, puddles, stairwells) or enclosed spaces (for example, bulk 

raw material storage bins) without constant ventilation. Take active ventilation measures 

in these areas and similar areas.

2. After molding or cutting, a pentane ring may appear immediately around the molded 

foam product. After that, the pentane ring will gradually disappear, and it will no longer 

be obvious after 7 days of storage at room temperature. When the pentane concentration 

in a molded foam product decreases during inspection, storage, transportation, and use 

(10 to 14 days after normal molding), the pentane vapor does not pose a fire hazard. 

Shaped foam products should be placed in a well-ventilated area for aging and storage


About Epsole


about epsole.jpg